Description

Leyland Trade Undercoat is a high covering, alkyd-based undercoat, the ideal foundation for gloss. Suitable for interior and exterior use providing a smooth surface on both wood and metalwork.

Coverage Rate: Leyland estimate that 1 litre will cover approximately 17 square metres, depending on the nature and porosity of the surface.

Drying time: Leyland Trade Undercoat should be touch dry in approximately 4-6 hours and recoatable after 16-24 hours.

Preparation

Ensure surface to be painted is sound, clean, dry and free from grease.
Remove all loose and defective paint.
Prime all new and bare surfaces with the appropriate Leyland Primer.
Rub down sound previously painted surfaces with fine waterproof abrasive paper to provide a key.
Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.
Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.

Application

Stir well before use.
Suitable for application by brush or roller. The brush should be fully loaded for best results.
Do not thin.
Apply one or more coats as required and allow 16-24 hours drying between coats under normal conditions.
Do not apply over polystyrene surfaces.

Cleaning

Remove as much product as possible from application equipment before cleaning.
Clean equipment immediately after use with White Spirit or Turpentine Substitute.
Some local authorities have special facilities for disposal of waste coatings. Do not empty product into drains or watercourses.
Replace lid firmly.

Warning

Keep out of reach of children.
Avoid contact with skin and eyes.
Do not ingest.
If medical advice is needed have container or label to hand.
Please refer to Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling/use/transport/storage/disposal/emergency.