Description
Blackfriar Brick & Tile Paint provides a tough, self-cleaning, weather-resistant finish. In attractive matt tile red, it’s ideal for doorsteps, roof tiles, bricks and masonry, both inside and outside. Revive your faded bricks and tiles with Blackfriar Brick & Tile Paint.
Preparation
Make sure the surface to be painted is clean, dry and free from any contaminants. Remove any mould – if using an anti-mould solution then allow to dry completely.
Application
Stir well with a broad stirrer. The manufacturer recommends two coats for the best protection. The product can be applied with brush, roller or spray, but applying with a brush is recommended. Only thin to a maximum of 5% white spirit. Do not paint in cold (under 5°C), damp or humid conditions. Not suitable for floors/foot traffic areas or for quarry tiles.
- Coverage of up to 14m² per litre per coat
- Touch dry in 2-4 hours
- Recoat after 16 hours and within 3 days
Drying times are based on an ambient temperature of 20°C and 50% relative humidity. Lower temperatures or higher humidity will prolong the drying and overcoating times.
Caution
- Not suitable for use on quarry tiles. Blackfriar have specific products for floors and steps.
- Do not use under cold (less than 5°C), damp or humid conditions.
- Spreading rate of the first coat may be reduced on porous surfaces.
- Store in a dry, safe place. Do not store in environments where extreme temperatures may occur. Keep within 5-30°C. Do not store in direct sunlight.
Safety
- Keep out of reach of children.
- Read label before use.
- Flammable liquid and vapour. Keep away from heat, sparks, open flames, hot surfaces.
- Use only in well-ventilated areas. May cause drowsiness or dizziness.
- If on skin, rinse skin with water or shower.
- If medical advice is needed, have product container or label at hand.
Living-room 
Kids-room 
Bedroom