Everbuild Fix & Fill Foam 500ml

Description

Everbuild Fix & Fill Foam is a quick setting polyurethane based foam which expands greatly on application and yields up to 150 times original can contents. This foam can be cut, sawn, plastered and sealed over after approximately one hour. Fills irregular gaps, fixes framework, insulates and sound deadens.

Everbuild Fix and Fill Quick setting one part polyurethane expanding foam a multi use frame fixing foam it is Quick-setting and can be cut, sawn or plastered in 1 hour

Everbuild Fix & Fill Foam is supplied with an attachable straw nozzle. Adheres to many surfaces including plastic, masonry, metal, stone, brick and plaster.

Filling

• Gaps around pipe entries through walls.
• Gaps around window frames, door frames.
• Electrical wire chasing prior to plastering.
• Deep joints prior to applying sealant or plaster.
• Irregular gaps in stone, brick, concrete or plaster.

Fixing

• Door frames
• Timber structures
• Window sills and thresholds
• Window frames

Insulating

• Behind cladding to exterior walls
• Behind soffit and barge boards

Features

• Quick setting – can be cut, sawn or plastered in 1 hour.
• Economical in use – expands up to 55 times its original volume.
• Fills irregular and broad gaps where most conventional fillers would fail.
• Possesses insulating and sound deadening properties.

Application

• ALWAYS WEAR PROTECTIVE GLOVES.
• Shake can well before use (about 20 times).
• Carefully fix nozzle. Do not overtighten or force.
• ALWAYS USE CAN UPSIDE DOWN.
• Only partially fill cavities as the foam will expand to fill the remaining space.
• Any excess foam can be removed whilst still wet. Cured foam must be removed mechanically.
• When used for fixing door frames, supports must be used until the foam is fully cured.
• Please note: When transported in cars, keep upright and secured in boot, out of direct sunlight.
• When removing cured foam from skin, take care not to damage with abrasives.
• Grease skin with body lotion or similar.
• IMPORTANT – Re-use is only possible by cleaning the nozzle and valve tip with Everbuild® FOAM CLEANER before the foam has cured. Do not push any object into the valve as the contents may explode.