Leyland Trade Truguard Flexible Exterior Undercoat – 2.5ltr

Description

Leyland Trade Truguard Flexible Exterior Undercoat is specifically formulated to be used in conjunction with Leyland Truguard Flexible Exterior Gloss to provide an exceptionally flexible, durable and water-resisting gloss system for exterior timber and metal.

Preparation

• Ensure surface to be painted is sound, clean, dry and free from grease.
• Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.
• Special precautions should be taken during surface preparation of pre 1960’s paint surfaces over wood and metal as they may contain harmful lead.

Bare Wood

Ensure the wood has a moisture content of less than 20%. Treat knots and resinous areas with two thin coats of Knotting Solution. Apply one coat of preservative to all bare timber paying particular attention to end grain and joints. Fill any surface defects, holes or joints using a Two Pack Wood Filler. Apply one coat of Leyland Truguard Flexible Exterior Undercoat followed by two coats of Leyland Truguard Flexible Exterior Gloss.

Bare Metal

Remove any rust and corrosion and apply a suitable metal primer. Apply one coat of Leyland Trade Truguard Flexible Exterior Undercoat followed by two coats of Leyland Truguard
Flexible Exterior Gloss.

Previously Painted Surfaces

For maximum performance, old paint or varnish should be completely removed.

Unsound Condition: Remove all existing coatings using a hot air stripper or All Purpose Paint & Varnish Remover. Rub down the bare timber using fine waterproof abrasive paper – leaving it in a clean and smooth condition. Then treat timber as per Bare Wood. Wear a suitable face mask when dry sanding.

Sound Condition: Clean down the surface with Sugar Soap and abrade – to ensure maximum protection apply one coat of Leyland Trade Truguard Flexible Exterior Undercoat followed by two coats of Truguard Flexible Exterior Gloss, allowing 16-24 hours between coats.

Application

• Stir well before use.
• Do not thin.
• Suitable for application by brush or roller.

Cleaning

• Remove as much product as possible from application equipment before cleaning.
• Clean equipment immediately after use with white spirit or turpentine substitute.
• Some local authorities have special facilities for disposal of waste coatings.
• Do not empty product into drains or watercourses.
• Replace lid firmly.

Warning

• Keep out of reach of children.
• Avoid contact with skin and eyes.
• Do not ingest.
• If medical advice is needed have container or label to hand.
• Please refer to Product Label & Safety Data Sheet (SDS) for hazard warnings and information on safe handling/use/transport/storage/disposal/emergency.