Osmo UV Protection Oil – 420 Rapid Clear

£27.29£79.57 inc VAT

  • Clear Satin Finish
  • Highly water and dirt resistant
  • Reduces shrinkage and wood swelling
  • Delays natural greying 12 x better than bare wood
  • Resistant to mould, mildew and fungal attack
  • Will not blister or crack
  • Microporous, will not crack, flake or blister
  • Drying: 12 hours between coats
  • Coverage: Approx 18sqm per 1lt per coat

STEP 1 - Select Color:

Try different shades of each color range

Description

Osmo UV Protection Oil 420 Rapid Clear Satin finish enhances the natural characteristics of the wood and can be used on its own on vertical surfaces where it offers up to 12 times protection against UV degradation of the lignin in the wood. Osmo UV-Protection-Oil 420 is based on natural vegetable oils. Natural oils penetrate deeply into the wood, keeping it elastic and healthy, and preventing it from drying and becoming brittle.

420 Enhances the natural character of the wood., and contains biocides to protect against algae, mildew and fungal attack.

SURFACE PREPARATION

Wood surface must be clean, dry and frost-free (moisture content max. 20%). Ideally, surfaces are sanded no finer than a P120 grit grade of sand paper. Sanding to finer grades will reduce required absorbency.

Osmo UV-Protection-Oil Exra is ready to use. Do not thin. Stir well using a flat stirring stick or spatula before use. If possible, and if the wood is an absorbent species, please apply the first coat to all sides before installation.

Fresh wood containing natural wood ingredients /extractives (eg: Cedar, Larch, Teak, Mahogany or Iroko) are often less absorbent and need to weather off first before applying the product. Please refer to website ‘Suitability’ section for more details. Weathering helps ingredient rich wood become more absorbent and the wood finish adheres optimally. Weathering is also required if ingredient rich wood has been freshly sanded or renovated.

A coloured base coat is recommended, e.g. Natural Oil Wood stain. Coloured base coats can improve UV protection.

For renovations, clean old microporous wood finishes thoroughly. De-grey any weathered bare wood with Osmo Wood Reviver Power-Gel before applying an Osmo exterior product.

Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works. To maintain absorbency, avoid sanding surfaces finer than a P120 grit. Weather ingredient rich wood after sanding.

The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.

Soft wood species like Pine or Spruce are more prone to blue stain, rot and insects. If desired, pre-treat these soft woods if possible on all sides with Osmo WR Base Coat.

METHOD OF APPLICATION
  • With Osmo Flat Brush or Osmo Microfibre Roller, apply thinly along the wood grain and spread well.
  • Allow to dry for approx. 12 hours. Cooler temperatures, higher humidity levels or over application will delay drying. Once dry, apply the second coat thinly.
  • When recoating colour treated surfaces, or for renovation works, one coat applied to the clean and dry surface is usually sufficient.

We strongly recommend that you complete a small test area before commencing your job.

For more information please refer to the Technical Data Sheet.

Osmo UV Protection oil Video: Press

Additional information

Size

,

Select options This product has multiple variants. The options may be chosen on the product page